The Setup Tab - Mac Address Clone; Figure 5-11: Setup Tab - Mac Clone - Linksys WRT54GP2 User Manual

Wireless-G Broadband Router with 2 Phone Ports

The Setup Tab - MAC Address Clone

A MAC address is a 12-digit code assigned to a unique piece of hardware for identification, like a social security
number. Some ISPs will require you to register a MAC address in order to access the Internet. If you do not wish
to re-register the MAC address with your ISP, you may assign the MAC address you have currently registered with
your ISP to the Router with the MAC Address Clone feature.
MAC Clone
MAC Clone Service. To use MAC address cloning, select Enable.
MAC Address. Enter the MAC Address registered with your ISP. Then click the Save Settings button.
Clone. If you want to clone the MAC address of the PC you are currently using to configure the Router, then click
the Clone button. The Router will automatically detect your PC's MAC address, so you do NOT have to call your
ISP to change the registered MAC address to the Router's MAC address. It is recommended that the PC registered
with the ISP is used to open the MAC Address Clone screen.
When you have finished making changes on this screen, click the Save Settings button to save the changes, or
click the Cancel Changes button to undo your changes. Help information is shown on the right-hand side of a
screen. For additional information, click More.
Chapter 5: Configuring the Wireless-G Broadband Router with 2 Phone Ports
The Setup Tab - MAC Address Clone

Figure 5-11: Setup Tab - MAC Clone

mac address: the unique address that a
manufacturer assigns to each networking device.
19