Wireless-g broadband router with rangebooster (81 pages)
Summary of Contents for Linksys WRT54G3GV2-VF
Page 1
Package Contents • Wireless-G Router for 3G/UMTS Broadband • Setup CD-ROM • User Guide and Quick Installation on CD-ROM • AC Power Supply with UK, Euro, and Australia Plug Adapters • Car Power Adapter • Ethernet Cable WRT54G3GV2-VF Model No:...
Page 3
Overview There are two ways to set up the Router for Internet connection. Select one. Broadband WAN and 3G/UMTS Broadband 3G/UMTS Broadband Only Before you begin, make sure that you have the following: Broadband WAN and 3G/UMTS Broadband • Activated 3G/UMTS broadband service from Vodafone •...
Page 4
Overview To accept the license agreement, click Next. Accept the License Agreement Accept the License Agreement Make sure the Router is powered off. Insert the Vodafone 3G/UMTS Broadband Device into the Router’s PC Card slot or USB port. Click Next. Insert the Vodafone 3G/UMTS Broadband Insert the Vodafone 3G/UMTS Broadband Device...
Page 5
1� Broadband WAN and 3G/UMTS Broadband Make sure the Router is powered off. Disconnect the network cable from your computer. (This is the cable that connects the computer to your modem.) Click Next. Disconnect the Modem Disconnect the Modem Connect the cable from the modem to the Modem port on the Router.
Page 6
Broadband WAN and 3G/UMTS Broadband Connect the other end of the yellow cable to one of the yellow Ethernet ports labeled 1- on the side panel of the Router. Repeat steps C and D to connect additional computers or other devices to the Router.
Page 7
Broadband WAN and 3G/UMTS Broadband Follow the on-screen instructions to complete the setup and configuration. NOTE: For advanced configuration changes, refer to “Chapter 3: Advanced Configuration” in the User Guide on the CD-ROM.
Page 8
2� 3G/UMTS Broadband Only Connect the included yellow network cable to the Ethernet network port of your computer. Click Next. Connect the Network Cable to Connect the Network Cable to the Computer the Computer Connect the other end of the yellow cable to one of the yellow Ethernet ports labeled 1- on the side panel of the Router.
Page 9
3G/UMTS Broadband Only The Power LED will flash for about a minute during the self-test. It will be solidly lit when the self-test is complete. If the Power LED does not stop flashing, refer to “Appendix A: Troubleshooting” in the User Guide on the CD-ROM.