Table of Contents
Advertisement
trouBLeSHootinG
PROBLEM
I can't access the camera from a
web browser.
Viewer got disconnected during
monitoring.
I cannot connect to the system
using a tab browser of Internet
Explorer 7.0.
The camera connected to the
network is not detected in the IP
installer program.
Images overlap.
No image appears.
y Check to make sure that the camera's Network settings are appropriate.
y Check to make sure that all network cables have been connected
properly.
y If connected using DHCP, verify that the camera is able to acquire
dynamic IP addresses without any problem.
y If the camera is connected to a router, verify that port forwarding is
properly configured.
y Connected Viewers become disconnected upon any change to camera or
network configurations.
y Check all network connections.
y If the camera is connected over an PPPoE network, it' s possible for
Viewer to disconnect under poor network conditions.
y When you try to connect to the system using a tab browser, the same
cookie information is shared, resulting in errors when connected.
Therefore, instead of using a tab browser, open a new browser window
to connect to the system.
y Turn off the firewall settings on your PC and then search the camera
again.
y Check whether two or more cameras are set to a single multicast address
instead of different addresses. If a single address is used for multiple
cameras, the images may overlap.
y If the transmission method is set to multicast, check whether there is a
router that supports multicast in the LAN the camera is connected to.
SOLUTION
English _105
Advertisement
Table of Contents
