Kenwood KVT-7012BT Instruction Manual page 55

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (e.g., the sound may skip).
7
Reconnect the · battery.
8
Press the reset button.
9
Configure <Initial Setup>. (Page 4)
Installing the unit
Installing the unit
·
1
Detach the sleeve from the unit
2
Sleeve
Screws removed when detaching the sleve in step 1
• Bend the tabs of the mounting sleeve with a
screwdriver or similar utensil and attach it in place.
ENGLISH 55