Setup Field(S) - Motorola LS3578 Product Reference Manual

12 - 24 LS3578 Product Reference Guide
Send Data (continued)
Send Next 19 Characters

Setup Field(s)

Setup Field(s) Definitions
Table 12-1
Parameter
Move Cursor
Move Cursor To a Character
Move Cursor to Start of Data
Move Cursor Past a Character
Skip Ahead "N" Characters
Skip Back "N" Characters
Send Preset Value
Scan the Move Cursor To Character on page 12-25, then any
printable ASCII character from the Alphanumeric Keyboard on page
12-86. When this is used, the cursor moves to the position after the
matching character. If the character is not there, the rule fails and
ADF tries the next rule.
Scan this bar code to move cursor to the beginning of the data.
This parameter moves the cursor past all sequential occurrences of a
selected character. For example, if the selected character is 'A', then
the cursor moves past 'A', 'AA', 'AAA', etc. Scan the Move Cursor Past
Character on page 12-25, then select a character from the
Alphanumeric Keyboard on page 12-86. If the character is not there,
the cursor does not move (i.e., has no effect).
Scan one of these bar codes to select the number of positions ahead
to move the cursor.
Scan one of these bar codes to select the number of positions back
to move the cursor.
Send Values 1 through 6 by scanning the appropriate bar code.
These values must be set using the prefix/suffix values in
on page 7-20.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
Send Next 20 Characters
Description Page
12-25
12-25
12-25
12-26
12-28
12-28
Table 7-4