Scanning Sequence Examples; Errors While Scanning; User Preferences Default Parameters - Motorola LS3578 Product Reference Manual

5 - 2 LS3578 Product Reference Guide

Scanning Sequence Examples

In most cases, scan only one bar code to set a parameter value. For example, to set the beeper tone to high, scan
the High Frequency (beeper tone) bar code under Beeper Tone on page 5-5. The scanner issues a fast warble
beep and the LED turns green, indicating a successful parameter entry.
Other parameters, such as Laser On Time or Data Transmission Formats, require scanning several bar codes.
See the parameter description for this procedure.

Errors While Scanning

Unless otherwise specified, if an error is made during a scanning sequence, re-scan the correct parameter.

User Preferences Default Parameters

Table 5-1 lists the defaults for user preference parameters. To change any option, scan the appropriate bar code(s)
provided in User Preferences on page
NOTE See
miscellaneous default parameters..
User Preferences Default Table
Table 5-1
User Preferences
Default Parameters
Beeper Tone
Beeper Volume
Laser On Time
Beep After Good Decode
Trigger Mode
Aim Duration
Beep on Insertion
Time Delay to Reduced Power Mode
Transmit Code ID Character
Scan Angle
Prefix Value
Suffix Value
5-4.
Appendix A, Standard Default Parameters
Parameter
for all user preference, host, symbology, and
Default
Restore Defaults 5-4
Medium 5-5
High 5-6
3.0 sec 5-7
Enable 5-7
Level 5-8
0.0 sec 5-9
Enable 5-9
1 Second 5-10
None 5-11
Normal Angle 5-11
7013 <CR><LF> 5-12
7013 <CR><LF> 5-12
Page
Number