Condensed Water - Asko T744C W Operating Instructions Manual

Installation instructions
Install in a closet
ASKO's front panel controls make it possible
to install the washers and dryers in a closet.
Make sure there is a ½" (12 mm) minimum
clearance between units and cabinet or wall
and a 1" (25 mm) minimum clearance between
the rear edge of the machine top panel and the
cabinet or wall. To ensure proper ventilation,
we recommend louvered doors, particularly for
condenser dryers. Otherwise there must be
ventilation openings in the door. See illustration
for minimum ventilation openings:
NOTE!
Ensure the dryer door can be opened without
hindrance after installation.
NOTE!
The cool air intake panel at the front of the dryer
must not be blocked or covered. Doing so could
cause a fault.

Condensed water

Install the dryer so the condensed water will
continuously flow into a drain or sink. To do this,
follow the instructions below:
1 Connect the rubber hose supplied with the
dryer to the blue nipple.
2. Run the hose to a drain or sink, as illustrated.
NOTE!
The drain hose must not be more than 40"
(100 cm) above the floor.
Customer Care Center
1-800-898-1879
www.askona.com
23