Weber Spirit E-210 Owner's Manual page 11

REMOVE CONTBOL KNOBS & CONTROL PANEL FOR LEAK
TESTING
Yau will need: Phillips screwdriver.
1 ) Take otf the burner control knobs.
2)
Bemove screw and washer from back of control panel with a Phillips screwdriver
3)
Bemove machine screw f rom lower left and rtght side of conlrol panel with a
P h i l l r p s s c r e w d n v e r .
4 )
T i l t t h e b a c k e d g e o f t h e c o n t r o l p a n e l u p . C a r e f u l l y l i f t c o n l r o l p a n e l u p a n d a w a y
f rom f rame.
5 ) D i s c o n n e c t t h e r g n i t e r w r r e s f r o m t h e i g n i t i o n m o d u l e .
0 )
R e p l a c e c o n t r o l p a n e l w h e n L e a k C h e c k i s c o m p l e t e d .
A WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
Note: All factorv-made connecttons have been thoroughly checked for gas leaks. The
burnerc have been flamelested. As a safety precaution however, you should recheck
all fittings for leaks before ustng your Weber Gas Barbecue. Shipping and handling
may loosen or damage a gas fitting.
A WARNING: Perform these leak checks even if your barbecue
was dealer or store assembled.
Y o u w i l l n e e d : a s o a p a n d w a t e r s o l u t i o n , a n d a r a g o r b , r u s h t o a p p l y l t .
ivote: Slnce some leak testso/ullons, including soap and water, may be slghtly
corrosive, all connections should be rinsed with water after checkng tor leaks.
l f y o u r g r i l l h a s a s i d e b u r n e r m a k e s u r e l h e s i d e b u r n e r i s o f f .
T o p e r f o r m l e a k c h e c k s : o p e n c y l i n d e r v a l v e b y t u r n i n g t h e c y l i n d e r v a l v e h a n d - w h e e l
c o u n t e r c l o c k w r s e .
A WARNING: Do not ignite burners when leak checking.
C h e c k f o r l e a k s b y w e t t i n g t h e c o n n e c t i o n s w i t h t h e s o a p a n d w a t e r s o l u t l o n a n d
w a t c h i n g f o r b u b b l e s . I t b u b b l e s f o r m o r t f a b u b b l e g r o w s , t h e r e i s a l e a k .
C H E C K F O R G A S L E A K S
A D A N G E R
Do not use an open flame to check for gas leaks. Be sure
there are no sparks or open flames in the area while you
check for leaks. Sparks or open flames will result in a fire or
explosion, which can cause serious bodily injury or death
and damage to property.
+1v @
IUU@5