Weber Spirit E-210 Owner's Manual page 10

To Connect the hose to the cylinder:
1 ) O D e n b a s e c a b i n e t d o o r s .
2 )
P a s s t h e r e g u l a t o r h o s e t h r o u g h t h e s i d e p a n e l o p e n i n g t o t h e i n s i d e o f t h e b a s e
c a b i n e t .
3 )
S l i d e t h e h o s e r e t e n t i o n b r a c k e l ( 1 ) a l o n g t h e h o s e a n d t h r o u g h t h e s i d e p a n e l
o p e n i n g t o t h e i n s i d e o f t h e b a s e c a b i n e i .
4)
Position the hose retention bracket on the right inside panel and secure with two
herwasher/bolts (2).
A WARNING: The hose must be secured to the side panel with
the Hose Retention Bracket. Failure to do so could cause
damage to the hose resulting in a fire or explosion which
can cause serious bodily injury or death, and damage to
property.
T h e L P c y l i n d e r i s i n s t a l l e d i n s i d e t h e b a s e c a b i n e t .
5 ) T u r n t h e L P c y l i n d e r s o t h e o p e n i n g o f t h e v a l v e i s e i t h e r t o t h e J r o n t , s i d e o r r e a r o f
the Weber' gas barbecue.
6 )
L i f t a n d p l a c e t h e c y l i n d e r i n t o t h e t a n k b a s e o p e n i n g I n t h e b o t t o m p a n e l .
W e b e r r e c o m m e n d s t h e u s e o f c y l i n d e r m a n u f a c t u r e r ' s l \ , 4 a n c h e s t e r
a n d W o r t h i n g t o n ,
with a 476 lb water capacity. Other cylinders may be acceptable for use with the
a p p l i a n c e p r o v i d e d t h e y a r e c o m p a t i b l e w i t h t h e a p p l i a n c e r e t e n t i o n m e a n s ( s e e
i l l u s t r a t i o n s ) .
7 \
R e m o v e t h e D l a s t i c d u s t c o v e r f r o m t h e v a l v e .
8 ) S c r e w t h e r e g u l a t o r c o u p l i n g o n t o t h e t a n k v a l v e , c l o c k w i s e , o r t o t h e r i g h t .
Hand-tighten only.
Note: Ihls is a new type of connection. lt tightens clockwise and will not allow gas to
flow unless the connectton is tight.The connection requires ttghtening by hand only.
A WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
You will need: LP cylinder,a soap and water salution and a rag or brush to apply it.
9 )
M i x s o a o a n d w a t e r .
1 0 ) T u r n o n t h e c y l i n d e r v a l v e .
11 ) Check for leaks by wetting the fitting with the soap and water solution and watching
f o r b u b b l e s . l f b u b b l e s f o r m , o r i f a b u b b l e g r o w s . t h e r e i s a l e a k .
lf there is a leak, turn off the gas and tighten the fitting.Turn the gas back on and
recheck with the soap and water solution.
lf leak does not stop, contact the Customer Service Representative in your area
using the contact information on our web site. Log onto www.weber.com@. Do not
use the barbecue.
1 2 ) W h e n l e a k c h e c k i n g i s c o m p l e t e , t u r n g a s s u p p l y O F F a t t h e s o u r c e a n d r n s e
connections with water.
ruili/lit+Eilq!1ll