Selecting And Installing The Contact Points; Dog Training - Garmin Sport PRO Owner's Manual

the dog's neck. The dog must be able
to swallow food and water normally.
You should observe your dog's
behavior to verify that the collar is not
too tight.
3
Wiggle the device to work the contact
points through the dog's coat.
NOTE: The contact points must have
contact with the dog's skin to be
effective.
4
If the strap is too long, cut off the
excess, leaving at least 8 cm (3 in.) to
spare.
TIP: You can mark the hole used to
fasten the buckle for future reference.
6
Selecting and Installing the Contact
Points
For best results, select the correct contact
points based on your dog's coat.
1
Select the correct contact point length
for your dog's coat type:
• For dogs with thicker coats, use
the longer contact points.
• For dogs with shorter coats, use
the shorter contact points.
2
If necessary, use the included wrench
to remove the contact points.
3
Twist the contact points into the collar.
4
Tighten with the included wrench, but
do not overtighten.
When you put the collar on the dog, make
sure the contact points are tight against
the neck.

Dog Training

You should research and investigate the
training methods best suited for you, your
dog, and your needs.
When used properly, the Sport PRO
training system is an effective training tool
to aid your dog in reaching its full potential.
Dog Training