Restarting the Device ..............6 ANT+® Connections ..............6 Pro 550 Plus Handheld Device Components ......6 Replacing the Pro 550 Plus Handheld Device Battery ....6 TT 15 Battery Replacement Instructions ........6 TT 15 Components ..............6 Removing the Old Battery ............6 Installing the New Battery ............
Setting Up the Pro 550 Plus System calibrate the handheld device (Calibrating the Compass on the Handheld Device, page Before you can use the Pro 550 Plus system, you must set up Battery level of the dog collar device. the devices. Charge the handheld device (Charging the Handheld Device, Unknown battery status.
Lift the weather cap On the handheld device, select a paired collar with the toggle switch. When the dog collar device has acquired satellite signals, the status LED flashes a double-blink or triple-blink in green. When the handheld device has acquired satellite signals and communicated with a paired dog collar device, it displays status information for the dog collar device (Handheld Device Screen,...
If there is no reaction, increase the intensity level by one level When used properly, the Pro 550 Plus training system is an until the dog has a slight but recognizable reaction to the effective training tool to aid your dog in reaching its full potential.
Training Key Functions The Pro 550 Plus system provides several training modes, which assign different combinations of momentary stimulation, continuous stimulation, and tone to the training keys. The three vertical letters next to the mode toggle switch correspond to the training key functions, from top to bottom.
*The device withstands pressure equivalent to a depth of 10 m. computer. For more information, go to www.garmin.com/waterrating. Getting More Information Checking the Battery Level of the Handheld You can find more information about this product on the Garmin Device website. Turn on the handheld device (Turning On the Device, •...
Back plate Battery Battery connector Front plate Gasket Replacing the Pro 550 Plus Handheld Device Battery Before you replace the battery, you must remove all dirt, water, Back plate and debris from the device. You also need a small Phillips...
After you remove the old battery, contact your local waste Replace the battery plate, and replace and tighten the two disposal department to properly recycle the battery. screws. Installing the New Battery Before you replace the battery, you must remove the old battery (Removing the Old Battery, page 6).