Selecting And Installing The Contact Points - Garmin Tri-Tronics PRO70 Owner's Manual

In order to properly correct the dog, the
collar and device must fit the dog
properly. If the collar is too loose or
positioned incorrectly, corrections may be
inconsistent. This can delay or prevent
successful training.
1
Place the collar around the middle of
the dog's neck.
2
Position the device at the front of the
dog's neck, with the status LED facing
toward the dog's chin and the contact
points against the throat.
3
Tighten the strap so that it is very
snug around the dog's neck, and
fasten the buckle.
NOTE: The collar should fit tightly and
should not be able to rotate or slide on
the dog's neck. The dog must be able
to swallow food and water normally.
You should observe your dog's
behavior to verify the collar is not too
tight.
4
Wiggle the device to work the contact
points through the dog's coat.
NOTE: The contact points must have
contact with the dog's skin to be
effective.
5
If the strap is too long, cut off the
excess, leaving at least 3 in. (8 cm) to
spare.
6
Mark the hole used to fasten the
buckle for future reference (optional).
Selecting and Installing the
Contact Points
For best results, select the correct contact
points based on your dog's coat.
7