ZyXEL Communications VMG8924-B10A Series User Manual page 207

Figure 102 Interface Group Configuration
The following table describes the fields in this screen.
Table 75 Interface Group Configuration
LABEL DESCRIPTION
Group Name Enter a name to identify this group. You can enter up to 30 characters. You can use letters,
numbers, hyphens (-) and underscores (_). Spaces are not allowed.
WAN Interface Select the WAN interface this group uses. The group can have up to one PTM interface, up to
used in the one ATM interface and up to one ETH interface.
grouping
Select None to not add a WAN interface to this group.
Grouped LAN Select one or more LAN interfaces (Ethernet LAN, HPNA or wireless LAN) in the Available
Interfaces LAN Interfaces list and use the left arrow to move them to the Grouped LAN Interfaces
list to add the interfaces to this group.
Available LAN
Interfaces To remove a LAN or wireless LAN interface from the Grouped LAN Interfaces, use the
right-facing arrow.
Automatically Click Add to identify LAN hosts to add to the interface group by criteria such as the type of
Add Clients the hardware or firmware. See
With the
following DHCP
Vendor IDs
# This shows the index number of the rule.
Filter Criteria This shows the filtering criteria. The LAN interface on which the matched traffic is received
will belong to this group automatically.
VMG8924-B10A and VMG8924-B30A Series User's Guide
Chapter 15 Interface Group
Section 15.2.2 on page 208
207
for more information.