Ioline FlexJet E Quick Start Manual page 26

26 Ioline FlexJet E Quick Start Guide
Step 4 : Taping Paper to the Take-Up Shaft
1. Stand in front of the machine.
2. Temporarily attach a short piece of masking tape to the center
of the cover on top of the machine.
3. Grasp the front edge of the paper. Push the pinchwheel lever to
raise the pinchwheels.
4. Hold the front edge of the paper with both hands and pull 20"
(51 cm) of paper over the platen and under the take-up shaft
(see Step 3 for the proper paper path). On machines with the
high speed printing kit, make sure the paper covers the rear
rolling top bar.
5. Apply pressure to the feed roll with a foot so that it does not
turn.
6. Align the paper by gently pulling it while moving it left and
right until the tension feels even. Attach the paper to the take-
up shaft using the piece of tape stuck to the cover.
7. Tape the right and left ends of the paper (about 2" or 5 cm in
from the edge) to the take-up shaft.
Tape the paper
in 3 places
Do not cover the hole in the platen
with paper.