Arriva Flue Components - Rinnai Arriva 750 Installation Manual

Arriva flue components

Direct A flue kit
Code = R2731
For use in walls 115-240 mm thick—
typically weatherboard construction
(can be cut to size). This is a complete
kit, no other components are required.
• Stainless steel
• Inbuilt 2° fall to drain condensate
Arriva adaption flue kit
Code = ASPKIT03
Used for all flueing configurations
EXCEPT standard direct flueing.
Elbow section of this component
(circled) requires a 25 mm clearance
from combustibles, the rest is zero
clearance. This kit also contains a
sub-kit called the condensate drain
kit (shown in next panel), and the flue
slide stopper (part 4822).
10 | Arriva 750 Installation Guide: 10473-C 03-13
Direct B flue kit
Code = R2732
For use in walls 240-400 mm thick—
typically block construction (can be cut
to size). This is a complete kit, no other
components required.
• Stainless steel
• Inbuilt 2° fall to drain condensate
Long End
Condensate
Short End
tray
Condensate
drain hose
Barb (top)
Condensate
Wire Tie
Tube
90° Bend
Condensate drain kit
Code = R1970
The condensate drain kit is provided
with ASPKIT03. It is used for internal
wall flue installations, or other vertical
flue installations that will require
draining of condensate back into the
heater.
Direct flue kit
Code = ASPDFK
For use in walls greater than
400 mm (can be cut to size). Can be
used in combination with ESPIPE900
for longer flueing. Kit includes flue
slide stopper (part 4822).
Flue terminal section is reusable when
making flue longer. Flue is aluminium,
collars are PVC, and spacers are PBT
plastic.
Coaxial flue pipe 900 mm
Code = ESPIPE900
Extension pipe (960 mm installed) used
to construct horizontal, vertical, and
downwards flueing. Can be cut to size.
Inner is aluminium, and outer is PVC
plastic. Comes with one wall bracket.
• O-ring for ESPIPE (4350)
• Spacer for ESPIPE (4351)