Clean The Centrifugal Engine Oil Cleaner - Yanmar 6SY Series Operation Manual

CAUTION
• NEVER overfill the engine with
engine oil.
• ALWAYS keep the oil level
between upper and lower lines
on the oil cap / dipstick.
11.Perform a trial run and check for oil
leaks.
12.Approximately 10 minutes after
stopping the engine, remove the oil
dipstick and check the oil level. Add oil
if the level is too low.
Clean the Centrifugal Engine Oil
Cleaner
A
WARNING
BURN HAZARD!
• If you must drain the engine oil
while it is still hot, stay clear of
the hot engine oil to avoid
being burned.
• ALWAYS wear eye protection.
• Failure to comply could result
in death or serious injury.

Clean the centrifugal engine oil cleaner

every time the oil is changed.
1. Clean the oil cleaner cover. Turn the nut
counterclockwise to remove. Carefully
remove the cover in case the oil is hot.
6SY Operation Manual
2. Lift out the rotor and turn the nut on the
rotor bowl counterclockwise three turns
(Figure 2).
0000015en
• If the nut is jammed, clamp the nut in a
NEVER clamp the rotor in a vise.
NEVER strike the rotor bowl.
Doing so may cause damage
resulting in imbalance.
0000011en
PERIODIC MAINTENANCE
Figure 2
vise and turn the rotor three turns
counterclockwise by hand or with a
wrench (Figure 3).
IMPORTANT
Figure 3
0002376
83