Gb Es Es; Installation; Unpacking And Levelling; Electric And Water Connections - Indesit WITL 85 Instructions For Use Manual

Installation


Keep this instruction manual in a safe place for
GB
future reference. Should the appliance be sold,
transferred or moved, make sure the instruction
manual accompanies the washing machine to inform
the new owner as to its operation and features.

Read these instructions carefully: they contain vital
information on installation, use and safety.

Unpacking and levelling

Unpacking
4. Seal the gaps using the plastic plugs provided.
5. Keep all the parts: you will need them again if the
washing machine needs to be moved to another
location.
Warning: should the screws be re-used, make sure
you fasten the shorter ones at the top.

Packaging materials are not children's toys.
Levelling
front feet (see figure); the angle of inclination,
measured according to the worktop, must not
exceed 2°.
2
1. Unpack the washing
machine.
2. Check whether the
washing machine has
been damaged during
transport. If this is the
case, do not install it
and contact your
retailer.
3. Remove the four
protective screws and
the rubber washer with
the respective spacer,
situated on the rear of
the appliance (see
figure).
1. Install the washing
machine on a flat sturdy
floor, without resting it
up against walls,
furniture cabinets or
other.
2. If the floor is not
perfectly level, compen-
sate for any unevenness
by tightening or
loosening the adjustable
Levelling your appliance correctly will provide it with
stability and avoid any vibrations, noise and shifting
during operation. If it is placed on a fitted or loose
carpet, adjust the feet in such a way as to allow
enough room for ventilation beneath the washing
machine.
Putting your appliance in place and moving it.
base. Once the appliance is in the required
position, put the lever back in place. The washing
machine is now firmly in place (see figure).

Electric and water connections

Connecting the water inlet hose
A
3. Make sure there are no kinks or bends in the
hose.

The water pressure at the tap must be within the
values indicated in the Technical details table
(on the next page).

If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
If your washing
machine is equipped
with a special set of
retractable wheels you
can easy move it. To
lower the wheels and
thus move the
appliance effortlessly,
just pull the lever,
situated on the left-
hand side beneath the
1. Insert seal A into
the end of the inlet
hose and screw the
latter onto a cold
water tap with a 3/4
gas threaded mouth
(see figure).
Before making the
connection, allow the
water to run freely
until it is perfectly
clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance's cold water
inlet, situated on the top
right-hand side on the
rear of the appliance
(see figure).