Network Interface Specifications - Oki C911dn User Manual

Specifications
Network interface specification
z Basic specifications
1
Network protocols
z For TCP/IP
z For EtherTalk
z Connectors
1000BASE-T / 100 BASE-TX / 10 BASE-T (Auto switching and simultaneous use are not possible)
2
Note
z The default factory setting is to disable 1000BASE-T.
If using with 1000BASE-T, use the control panel to make the following settings.
Set to [Administrator menu]> [Enter password> [Network Setup]> Gigabit Network]> [Enable].
z Cables
Unshielded twist pair cable with EJ-45 connector (category 5e or later)
3
z Connector pin array
4
z Interface signals
Pin Signal
No. name
1 TRD+(0) Data 0 sending and receiving (+)
2 TRD-(0) Data 0 sending and receiving (-)
3 TRD+(1) Data 1 sending and receiving (+)
4 TRD+(2) Data 2 sending and receiving (+)
5 TRD-(2) Data 2 sending and receiving (-)
6 TRD-(1) Data 1 sending and receiving (-)
7 TRD+(3) Data 3 sending and receiving (+)
8 TRD-(3) Data 3 sending and receiving (-)
Function
- 132 -