Wheels; Tire Replacement - Mercedes-Benz C-Class Operator's Manual

Instruments
Operation
and controls
Tires, Wheels
Warning!
The jack is designed exclusively for jacking up the
vehicle at the jack take-up brackets built into either
side of the vehicle. To help avoid personal injury,
use the jack only to lift the vehicle during a wheel
change. Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet away
from the area under the lifted vehicle. Always
firmly set parking brake and block wheels before
raising vehicle with jack.
Do not disengage parking brake while the vehicle is
raised. Be certain that the jack is always vertical
when in use, especially on hills. Always try to use
the jack on level surface. Be sure that the jack arm
is fully seated in the jack take-up bracket. Always
lower the vehicle onto sufficient capacity
jackstands before working under the vehicle.
Instrument
Driving
cluster display
Practical hints Car care
328

Wheels

Replace rims or tires with the same designation,
manufacturer and type as shown on the original part.
See your authorized Mercedes-Benz Center for further
information.
See your authorized Mercedes-Benz Center for
information on tested and recommended rims and tires
for summer and winter operation. They can also offer
advice concerning tire service and purchase.

Tire replacement

Front and rear tires should be replaced in sets. Rims
and tires must be of the correct size and type. For
dimensions, see "Technical Data".
We recommend that you break in new tires for
approximately 60 miles (100 km) at moderate speed.
Technical
Index
data