Samsung SUD-2080F User Manual page 14

Super high resolution utp dome camera
Hide thumbs Also See for SUD-2080F:
Table of Contents

Advertisement

Operating Your Camera
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL
4.SSDR
5.BACKLIGHT
6.SSNR3
2. Select a desired mode using the Function Setup switch depending on the camera purpose.
OFF : Not being used
BLC : Enables a user to select a desired area on a picture and view that area more clearly.
- LEVEL : Adjust level of the BLC function.
- TOP/BOTTOM/LEFT/RIGHT : Adjust the area to be enhanced.
HLC (High Light Compensation) :
If the scene contains extremely bright light areas such as; from car headlight, the
light can mask out much of the on-screen detail.
- LEVEL : Adjust level of the HLC function.
- LIMIT : Enable to change the operating condition.
- MASK COLOR/TONE : Change the color / brightness of the masking area.
(Black, Red, Blue, Cyan, Magenta)
- TOP/BOTTOM/LEFT/RIGHT : Adjust the area to be enhanced.
3. Select a desired mode using the Function Setup switch.
Select 'BLC' to adjust the area to be
enhanced then adjust the level.
26
COLOR DOME CAMERA
DC
ATW
OFF
OFF
ON
HLC : Enable the user to change the level,
limit, mask color/tone and area.
User Guide
Notes
• Because there can be a difference in the effectiveness of HLC according to the amount of
light area in the screen, optimize the installation angle for the best HLC performance.
• When dark, the HLC is only activated when a bright light exceeding a specific size. (In
NIGHT ONLY mode.)
• The HLC is not activated in day light or when bright light is not present at night. (In NIGHT
ONLY mode.)
SSNR3
This function reduces the background noise in a low luminance environment.
1. When the SETUP menu screen is displayed, select 'SSNR3' by using the Function Setup
switch so that the arrow indicates 'SSNR3' .
MAIN SETUP
1.LENS
2.EXPOSURE
3.WHITE BAL
4.SSDR
5.BACKLIGHT
6.SSNR3
7.DAY/NIGHT
2. Select a desired mode using the Function Setup switch.
ON : Activates SSNR3 so that noise is reduced.
OFF : Deactivates SSNR3. Noise is not reduced.
3. Set the SSNR3 mode to 'ON' and press the Function Setup switch. Then you can adjust
the noise reduction level.
COLOR DOME CAMERA
DC
ATW
OFF
OFF
ON
AUTO
27
User Guide

Advertisement

Table of Contents
loading

Table of Contents