Advertisement
®
HORIZONTALLY OR VERTICALLY MOUNTING THE H585
In order to install the H585 in the H588,
the H585's Trim Brackets must first be
mounted to the front of the H588 as
shown.
See Figure 2.
The H585 ships ready for horizontal
installation. Should you choose to mount
the H585 vertically, the H588 must also
be mounted vertically and the camera
module must be rotated 90 degrees.
NOTE: Regardless of the H585's
orientation, always make sure the wire
Figure 2 - Mounting the H585's Trim Brackets. Note the orientation of
protruding from the rear of the camera
the Trim Bracket's inner flanges.
module is located in the UPPER-RIGHT
corner when viewed from the rear! See
Figure 3
Once the camera module has been
repositioned, be sure to tighten the
bracket screw, securing the camera in
the desired position.
ADJUSTING THE VIEWING
ANGLE
The camera's viewing angle may also
be adjusted +/- 15 degrees by carefully
1. Use pliers or a 7/16 wrench to loosen
twisting the Camera Bracket.
the Set Screw and rotate the camera.
2. Make sure the Camera Wire is located
in the upper right corner when the
H585 is viewed from the rear.
POWERING THE H585 FROM
3. Adjust the viewing angle by carefully
A REMOTE LOCATION
twisting the Camera Bracket.
Figure 3 - Whether mounted horizontally or vertically, the Camera Wire
Most installations will require the H585
should always protrude from the UPPER-RIGHT corner when the H585 is
be powered from a remote location (i.e.
viewed from the rear.
the main equipment location).
To accomplish this, remove the
power connector from the power
supply (included) and the H585 as
shown to the J-Box wires - be sure
to maintain proper polarity on these
and the remotely located power supply
connections. NOTE: DO NOT remove
the H585 yellow (video) RCA jack
connector!
An "F-to-RCA" barrel connector is
included to facilitate the connection
of RG-6 or RG-59 coax cable to the
Figure 4 - Extending the H585's power supply cable using 18/2.
H585's RCA composite video connector.
Page 2
H585
INSTALLATION MANUAL
Camera
Bracket
Set
Screw
Camera
Wire
(Remove)
BLACK = ( - )
18/2 (for Power)
RED = (+)
12VDC
800mA
To
WHITE STRIPE
Video Modulator
is POSITIVE (+)
© 2004 Linear LLC. All Rights Reserved. 08/04
®
BRAND X
ELECTRONIC
DOOR LATCH
MECHANISM
DOORBELL
BUTTON
(INCLUDED)
Figure 5 - Connecting the H585 to an H560 amplifier. NOTE: 22 or 24 AWG 4 twisted pair wire with shield is
utilized so the color codes are not called out. Be sure to wire carefully as shown!
© 2004 Linear LLC. All Rights Reserved. 08/04
H585
INSTALLATION MANUAL
Page 3
Advertisement
