The Panel1 Connector - ECS K7VMM User Manual

SPK1: Speaker Connector
Connect the cable from the PC speaker to the SPK1 header on the mainboard.
Pin Signal Name
1 +5V
2 NC
3 Ground
4 SPKR
J1: Onboard LAN LED Connector
If you have a set indicator LEDs for the onboard LAN communication, you can
connect the LED cable to the header J1. Pins 1-2 are for Link LED, pins 3-4
are for 10/100 Mbps mode LED, the onboard LAN run in 100Mps mode when
the LED is lit.
Pin Signal Name
1 Link LED
2 GND
3 Ground
4 10/100 Mbps mode LED

The PANEL1 Connector

This panel connector provides a set of switch and LED connectors found on
ATX case. Refer to the table below for information.
Device
HDD_LED_P
PWR/ACPI LED
HDD_LED_N
RESET
POWER BUTTON
Key
Note: The plus sign (+) indicates a pin which must be connected to a positive
voltage.
Pins
1
1
2, 4
3
5, 7
6, 8
9, 10
9
9
2
10