NordicTrack T17.5 User Manual page 17

21. Orient the Storage Latch (53) so that the decal is
facing away from the treadmill as shown.
Attach the lower end of the Storage Latch (53) to
the bracket on the Base (94) with a 5/16" x 1 3/4"
Bolt (6) and a 5/16" Nut (12).
Raise the Storage Latch (53) to a vertical posi-
tion. Then, remove and discard the tie (K).
22. Align the upper end of the Storage Latch (53)
with the bracket on the Latch Crossbar (38).
Insert a 5/16" x 2 1/4" Bolt (3) through the
bracket. This should push a spacer (L) out of the
other end. Discard the spacer.
Attach the Storage Latch (53) with the 5/16" x
2 1/4" Bolt (3) and a 5/16" Nut (12).
Lower the Frame (56) (see HOW TO LOWER
THE TREADMILL FOR USE on page 28).
23. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 30 and 31). Note: Extra parts may be
included.
21
K
Decal
12
22
12
L
56
17
53
94
6
38
3
53