Scan On/Off; Nuisance Delete; High/Low Power; Talk Around/Repeater - Vertex Standard VZ-80 Operating Manual

Scan on: Touch the programmed side button, it starts
from current channel. When a channel receives signal
and squelch type is matching, the green LED indicator
lights on and stays in current channel.
Scan off: Touch the side button again to quit scanning.
Sometimes scanning will stay in a nuisance channel,
press "Nuisance delete" to delete the channel
temporarily from the scanning list, it won't be scanned
again in current operation. Enable scanning again and
it will be added to the list.
Shift from high/low power mode by enabling the
programmable button as high/low.
Enable the programmable side button REPEATER to
change the current channel repeater status. When
enabled, it displays the icon "
stops it is called talk around, at this time TX frequency
becomes the same as RX frequency, and TX PL/DPL
becomes the same as RX PL/DPL.
Press light button to turn ON/OFF backlight.
". When the repeater

Clone Function

You may use CPS read/write operation to clone
settings from one radio (master radio) to another
(target radio).

The Steps of Clone Operation:

a. Press and hold PTT
until "DI-" sounds, then release the 2 buttons and till "DI-" sounds, then release the 2 buttons and
"CLONE" is displayed. The master light is on
indicating. the radio is ready for cloning.
b. Connect the target radio to the master radio by
cloning cable, turn the target radio on.
c. Press the PTT button of the master radio, its red
light blinks and meanwhile the target radio with
green light blinks shows cloning; after about 28s
finish cloning, the master radio resets and waits for
next cloning request, the target radio resets
automatically.
d. If cloning failed, the master radio will display "ERR",
and the target radio reset automatically. Then press
the master radio PTT
displays "CLONE" again. Check if the cable is well
connected and repeat step c.
e. If more radios need to clone, please power off the
target radio and replace another radio, then repeat
step b & c.
f. To quit cloning, please power off the radio and
re-start again.
& Side button1 as power on
button, the master radio
29