Vertex Standard VZ-80 Operating Manual page 23

Press "F" + "2
TX power.
When TX power is high, it will display the "
To save power, you may select low power TX. This will
reduce the range.
Press "F" + "3
mode.
In FM VFO mode, the radio scans from FM frequency
87.0 to 108MHz, the scan stepping is 100 KHz. In FM
channel mode, saved FM channel frequency will be
scanned. If FM signal was detected, it will stop
scanning and stay in the active channel and listen.
Press " / "key to change scan direction or press any
other buttons to quit scanning.
In radio channel mode, the scan list channels will be
scanned. When channel bank is set, only same bank
channels are scanned. When a channel/frequency
signal is received and the squelch is matching, it will
stay in the channel and the green LED will light up,
press "PTT" to talk in that channel. If you do not want
to scan a channel, press "Nuisance Delete" side button
to skip the channel. The channel won't be scanned
again during current operation. In scanning, the icon
" " appears. Press " / " key to change scan
direction, press PTT button to TX on current channel,
press any other buttons to exit scan.
22
" Key: To switch high / low
PWR
" key: To enter scan
SCAN
Press "F" + "4
the repeater function.
When at different TX/RX frequencies, the repeater can
" icon.
be enabled. The icon "
enabled, and once pressing "F" + "4" keys, it will
change the repeater status. When the repeater stops it
is called "talk- around", at that moment the TX
frequency & PL/DPL becomes same as the RX
frequency & PL/DPL.
Press "F" + "5
item
While talking, release "PTT" to stop transmitting, there
is a harsh "ZaZa" sound heard by the RX user. Set
STE on can remove this noise.
There are 4 STE modes to select: frequency, phase
deviation 120°, phase deviation 180°, phase deviation
240°.
Note: This is effective only when the opposite radio has
the same STE mode.
Press "F" + "6SQT" key: To enter squelch
technology setting.
Display received PL/DPL for: no code as "R OFF", PL
as "R 67.0" or DPL as "R 023N", reversed DPL as
"R023I".
Press "6
" key: To enable or disable
REP
" is displayed as repeater is
" key: To set reverse burst
REV
" key to shift from above 4 types of
SQT