Lcd Backlit; Initialization; Led Indicator - Vertex Standard VZ-80 Operating Manual

b. Plug VOX accessory into the accessory jack.
c. Turn down the radio volume before speaking;
d. Speak into the microphone to TX, stop speaking to
RX.
When the Light option is default "KEY", pressing a key
on the front panel can light up the screen. If there is no
response after 5s after releasing "Light" button, the
light will be auto-off. When the light is on, press any
button except "Light" to restart the 5s timer, press
"Light" to turn off light immediately. If require light
always on, press "F" + "9" key to enter menu
selection mode and using " / " key to set the light.
To set the radio settings to default please press and
hold PTT, SB2 and SB1 together when turning on the
radio until a chatter sound heard. For Default settings
please refer to VZ-8 0 CPS initial values.
20

LED Indicator

Radio mode LED indication
Power on Red LED blinks 300ms
Power low Orange LED blinks 50ms every 2s,
gives low power alarm every 15
mins.
Standby
Red LED blinks
mode
50ms
Channel busy Green LED always on
Clone Orange LED always on
In cloning Master
subsidiary radio green LED blinks.
Low voltage Low voltage alarms every second, at
and power off the same time orange LED blinks
twice per second. It powers off after
10 seconds
Monitor Green LED always on
Standby Reading:
programming Writing : green LED blinks fast
mode
Scan mode Green LED blinks once every 0.6s
Sending voice Low power TX: orange LED always
on; High power TX: red LED always
on.
every 5s blinks
radio red LED blinks,
red LED blinks fast;