Preparation For Wall Mounting - Sony BRAVIA KDL-40S4100 Operating Instructions Manual

Other Information
Preparation for Wall Mounting
This TV can be installed on a wall by using a Wall-Mount Bracket (sold
separately). Before mounting the TV on a wall, the Table-Top Stand must be
removed from the TV.
(6 Do not remove the Table-Top Stand for any reason other than to wall-
mount the TV. .
Secure the Mounting Hook to the rear of the TV.
Adjust the angle of the Mounting Hook.
Start removing the screws behind the TV (See illustration below). Do
not remove any other screws from the TV.
Sony Wall-Mou nt
Bracket Model
SU-WL500
Follow the simple steps below to remove the Table-Top Stand:
1
Disconnect all the cables from the TV.
2
3
4
5
When screws are removed, lift the TV off the stand. Make sure that you
carry out this task with at least two people. Do not attempt to lift the TV
by yourself.
For bracket installation, refer to the instruction guide provided by the Wall-
Mount Bracket model for your TV. Sufficient expertise is required in
installing this TV, especially to determine the strength of the wall for
withstanding the TV's weight. For product protection and safety reasons,
Sony strongly recommends that you use the Wall-Mount Bracket model
designed for your TV and the wall-mounting of your TV should be
performed by Sony dealers or licensed contractors.
Be sure to use the screws supplied with the Wall-Mount Bracket when
attaching the mounting hooks to the TV set. The supplied screws are
designed so that they are 8 mm to 12 mm in length when measured from the
attaching surface of the mounting hook. The diameter and length of the
screws differ depending on the Wall-Mount Bracket model. Use of screws
other than those supplied may result in internal damage to the TV set or
cause it to fall, etc.
Screw (supplied with the Wall-Mount Bracket)
Mounting Hook
1 . . . - _ _
Rear of the TV set
(Continued)
39