Sony BRAVIA KDL-40S4100 Operating Instructions Manual page 20

Getting Started
2
Secure the TV to the Stand.
Use the optional hardware listed below (not supplied):
• M6
x
12-18mm anchor bolt (screwed into the TV's Table-Top Stand).
• A screw or similar (attach it to the TV stand).
• Rope or chain (strong enough to support the weight of the TV). Make
sure that there is no excess slack in the rope or chain.
An alternative way to secure the TV is with an optional Sony Support Belt Kit.
{6 Contact Sony Customer Support to obtain the optional Support Belt Kit,
0- ' •
3
by providing your TV modetname. .
- For United States call:
1-800~48a,.7669·
or.kisit:..wWw.sOny.com/accessories
~":::<; < . . ; .,
.;<:,. . . . .
, >:., )":';'" (:' : :,,::. . :.:., .,' ..,-,' " \ ~:" ",:,,:::,., ' : .;.>:.- ,-' , ' '('::: -' " ,.:',' .~"""
- For Canada call:
1-877-89~~7669"
'
3
Anchor the TV to the Wall.
Use the hardware listed below (not supplied).
• Two M6 x 12-18mm anchor bolts (screw into the top-most wall-
mount holes located on the rear of the TV).
• Rope or chain (attach to one M6 anchor bolt).
• Wall-anchor (attach to the wall stud) strong enough to support the
weight of the TV (pass the rope through the wall-anchor, then attach
to the other M6 anchor bolt).
Wall-anchor
~~~~~!-
Wall-mount
::: holes
Rope or
chain
Anchor bolts
--+-+-:-~---o":-"...;:M.
.{6 Measure 2 provides minimal protection against the TV toppling over.
For further protection, follow all three measures recommended above.
:
~
..
rt:n
If anelectric screwdriver is used, set the torque to tighten at
, approximately 2.0. N·m.{20. kgf:cm}. .
20