Your Dryer - Sunbeam 1636 Instruction Manual

With the control setting switch in the "O" position, plug the Dryer into a standard 125-Volt AC
outlet. Select speed (airflow) setting that is most appropriate to your needs and that will deliver
the best results.
The control setting switch marked "O", "Low" – "High" controls the airflow speed of your Hair
Dryer. Press up on the switch until it clicks into position LOW speed or press down on the
switch until it clicks into position HIGH speed.
When finished using your Dryer, move the control switch to the "O" position and unplug the
cord from the outlet.
COOL SHOT BUTTON (Refer to Diagram)
When drying hair use a higher heat setting and switch to a lower heat setting when drying is
nearly complete. To finish, press the Cool Shot Button. This will deactivate all heat flow from
the Dryer and blow cool air to lock in your hairstyle without causing over-drying or damage
to your hair.
CONCENTRATOR ATTACHMENT
Your Dryer comes equipped with an optional air concentrator attachment. Attach the concentra-
tor to the nozzle of your Dryer when you require extra airflow in certain areas.
Use to tighten a curl or wave or to loosen curly hair.
DUAL VOLTAGE SELECTOR (Refer to Diagram)
To change the voltage, insert a coin or screwdriver into the slot on the Dual Voltage Selector.
Turn, so that the desired voltage is lined up with indicator. A plug adaptor is necessary when
traveling to a country where the 250-volt setting is required.
If operating at 250-volts, the Dryer Switch must be operated only on the LOW setting. Do not
force the unit to the HIGH setting – the HIGH setting cannot be used in countries with 220 to
250 voltage. Even though the dryer setting is on LOW, the higher voltage coming into the unit
results in the unit operating at High Heat / Air Flow.
H T
oW o
A
DDiTioNAl
D V
UAL
u y
Se our
i
NForMATioN
S
OLTAGE ELECTOR
5
D
ryer