Lava Rocks & Ember Material; Flame & Temperature Adjustment; Flame Characteristics - Majestic 360DVS2 Installation Instructions & Homeowner's Manual

Vermont Castings, Majestic Products, 360DVS Series
Location of log cradle prongs in relation
to assembled logs (both sides are the same).
Fig. 42 Logs against log cradle prongs
Lava Rock & Ember Material
Your log set contains Ember Material and two types of
Lava Rocks. Set these materials in place after the logs
have been installed.
Ember Material (Pt. #10000055)
Remove ember material from the bag and separate it
into small pieces, then scatter it over burner tiles in a
random fashion. DO NOT pack down ember material;
leave it in a 'fluffy' state.
Burner Lava Rocks (Pt. #57897)
Remove burner lava rocks from packaging and spread
over burner tiles in a random fashion, filling in spaces
between logs.
Lava Rock (Pt. #10001454)
Remove lav rock material from packaging and spread it
over ceramic floor panels outside log stack. DO NOT
PLACE THIS LAVA ROCK material on burner tiles.
Flame & Temperature Adjustment
RN/ RP Models
For units equipped with 'HI/ LO' valves the flame
adjustment is accomplished by rotating the 'HI/ LO'
adjustment knob located near the center of the gas
control valve (Fig. 43 and Fig. 44).
Turn
counterclockwise
to decrease
flame height
Honeywell Valve
Fig. 43 Flame adjustment knob for Honeywell valve
Turn
counterclockwise
to increase
flame height
SIT 820 Valve
Fig. 44 Flame adjustment knob for SIT valve
26
Log & cradle
Turn clockwise
to increase
flame height
Honeywell HI/LO
Turn clockwise
to decrease
flame height
Nova 820 HI/LO

Flame Characteristics

It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to the
pictorials illustrated below (Fig. 45 and Fig. 46). If the
flame patterns appear abnormal, contact a qualified
service provider for service and adjustment.
Fig. 45 Correct burner flame appearance
PSE Pilot
CFM181
Fig. 46 Correct pilot flame appearance
Logs & flame
SIT Pilot
3 1
/ – / "
8 2
(9.5 – 13 mm)
Pilot_SIT
10002547