Section 6 − Welding Methods & Troubleshooting; Shielded Metal Arc Welding (Smaw) Procedure - Hobart STICKMATE LX Owner's Manual

SECTION 7 − WELDING METHODS & TROUBLESHOOTING
A. Welding Methods

7-1. Shielded Metal Arc Welding (SMAW) Procedure

Tools Needed:
1 Workpiece
Make sure workpiece is clean before welding.
2 Work Clamp
Place as close to the weld as possible.
3 Electrode
A small diameter electrode requires less current than a large one.
Follow recommendations of electrode manufacturer when setting
weld amperage (see 7-2).
4 Insulated Electrode Holder
4
2
1 7
Return To Table Of Contents
5
3
6
5 Electrode Holder Position
6 Arc Length
Arc length is the distance from the electrode to the workpiece. A
short arc with correct amperage will give a sharp, crackling sound.
Y Welding current starts as soon as electrode touches the
workpiece.
7 Slag
Use a chipping hammer and wire brush to remove slag. Remove
slag and check weld bead before making another weld pass.
mod5.1* 9/92
ST-151 593
OM-316 Page 29