Installation Procedure - Toshiba RAS-10N3KV-E Service Manual

10-1-1. Installation Diagram of Indoor and Outdoor Units
Filter
3 Batteries
2 Wireless remote control
Remark :
• Detail of accessory and installation parts can see in
the accessory sheet.
• Some pictures might be different from the actual parts.
• Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (− ) positions.

10. INSTALLATION PROCEDURE

5
6
Filter
8
Flat head
wood screw
Before installing the wireless remote controller
2 Wireless remote controller
Hook
1
Shield pipe
4
Remote control holder
Vinyl tape
Apply after carrying
out a drainage test.
Saddle
Extension
drain hose
(Not available,
provided by installer)
– –
45
FILE NO. SVM-12029
For the rear left and left piping
Installation
plate
Insert the cushion between the indoor
unit and wall, and tilt the indoor unit for
better operation.
Do not allow the drain hose to get slack.
Make sure to run the drain hose sloped
downward.
The auxiliary piping can be connected to
the left, rear left, rear right, right, bottom
right or bottom left.
Right
Rear
right
Bottom
right
Insulate the refrigerant pipes separately
with insulation, not together.
6 mm thick heat resisting
polyethylene foam
3 Batteries
Wall
Cut the piping
hole sloped
slightly.
Left
Rear
left
Bottom left