Finishing; Front Cast Removal; Glass Door Installation And Removal; Battery Housing Installation - Napoleon GDS60N Installation And Operating Instructions Manual

6.0 FINISHING

6.1

FRONT CAST REMOVAL

Lift the top casting off the unit.
A.
Loosen the securing bolts on the cast front (located at either side on the top). Lift up and out.
B.
To install the front, repeat in reverse order.
C.
6.2

GLASS DOOR INSTALLATION AND REMOVAL

When installing the glass door, a simple procedure must be followed in order to not damage the door.
Lift the top casting off.
A.
Lift the cast front out of its retainers (located at either side on the top).
B.
Open the valve control cover. Pull the latch handles forward to release. The door may now be safely
C.
removed by swinging the bottom out and lifting it off. To install the door, repeat in reverse order.
The return fl ange must fi t over the top of the ridge so that it rests on top of the fi rebox.
The 'T' latch portion is threaded and can be loosened or tightened to adjust for an effective door seal.
Care must be taken when re-installing the door to ensure that the gasket at the top of the door does
not bunch.
6.3

BATTERY HOUSING INSTALLATION

ENSURE THE GAS AND ELECTRICAL POWER IS TURNED OFF TO THE APPLIANCE.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL THE APPLIANCE HAS COOLED.
Insert 4 AA batteries (not supplied) into the battery housing supplied, note the polarity of the batteries
A.
and insert as indicated on the cover (+/-). (To open the battery housing slide the back piece upwards
and off of the battery housing).
Attach the wires from the wiring harness of the appliance to the battery housing.
B.
Place the battery housing into the valve compartment below the burner, ensure that the battery
C.
housing is placed in a clean and easily accessible location.
Turn the gas and electrical power back on to begin operating the appliance.
D.
LATCH
WARNING
!
37
EN
RETURN
FLANGE
RIDGE
W415-0788 / F / 10.21.13