Safety Instructions; General - DeWalt DC500 User Manual

Safety instructions

When using power tools, always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and
personal injury.
Read all of this manual carefully before operating
the tool.
Save this manual for future reference.

General

1 Keep work area clean
Cluttered areas and benches can cause accidents.
2 Consider work area environment
Keep the work area well lit (250 - 300 Lux).
Do not use the tool where there is a risk of
causing fire or explosion, e.g. in the presence of
flammable liquids and gases.
3 Keep children away
Do not allow children, visitors or animals to come
near the work area or to touch the tool or the
mains cable.
4 Dress properly
Do not wear loose clothing or jewellery, as these
can be caught in moving parts or caught by the
airflow. Wear protective hair covering to keep
long hair out of the way. When working outdoors,
preferably wear suitable gloves and non-slip
footwear.
5 Personal protection
Always use safety glasses. Use a face or dust
mask whenever the operations may produce
dust or flying particles. If these particles might be
considerably hot, also wear a heat-resistant
apron. Wear ear protection at all times. Wear a
safety helmet at all times.
6 Guard against electric shock
Prevent body contact with earthed surfaces
(e.g. pipes, radiators, cookers and refrigerators).
When using the tool under extreme conditions
(e.g. high humidity, when metal swarf is being
produced, etc.), electric safety can be improved
by inserting an isolating transformer or a (FI)
earth-leakage circuit-breaker.
7 Do not overreach
Keep proper footing and balance at all times.
8 Stay alert
Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
9 Use appropriate tool
The intended use is described in this instruction
manual. Do not force small tools or attachments
to do the job of a heavy-duty tool. The tool will
do the job better and safer at the rate for which it
was intended. Do not force the tool.
Warning! The use of any accessory or attachment
or performance of any operation with this tool
other than those recommended in this instruction
manual may present a risk of personal injury.
10 Check for damaged parts
Before use, carefully check the tool and mains
cable for damage. Check for misalignment and
seizure of moving parts, breakage of parts, damage
to guards and switches and any other conditions
that may affect its operation. Ensure that the tool
will operate properly and perform its intended
function. Do not use the tool if any part is damaged
or defective. Do not use the tool if the switch does
not turn it on and off. Have any damaged or
defective parts replaced by an authorised DeWALT
repair agent. Never attempt any repairs yourself.
11 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
12 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
13 Repairs
This tool is in accordance with the relevant safety
regulations. Have your tool repaired by an
authorised DeWALT repair agent. Repairs should
only be carried out by qualified persons using
original spare parts; otherwise this may result in
considerable danger to the user.
Safety instructions for mains-powered tools
14 Extension cables
Before use, inspect the extension cable and
replace if damaged. When using the tool
outdoors, only use extension cables intended for
outdoor use and marked accordingly.
E N G L I S H
7