Rheem MPi 551 Series Owner's Manual And Installation Instructions page 31

Cover Strip: (410 litre storage tank only) – Retrieve the length of rubber cover strip from the kit supplied
10.
with the 410 storage tank.
Line up one end of the cover strip with one end of the heat pump housing black top, fitting the strip

over the lip of the housing, ensuring the jacket is hard up against the lip of the heat pump housing.
The cover strip will hold the jacket in position.
Apply the cover strip along the full length of the lip of the heat pump housing.

COVER STRIP
Heat Pump Module Cover: Remove the two screws securing the front cover to the heat pump module.
11.
Remove the front cover from the heat pump module.

remove front cover from heat pump module and feed through cables
Position Heat Pump Module: Position the edge of the heat pump module which is closest to the wall
12.
against the storage tank so the screw holes in the module are adjacent to the nutserts in the storage
tank.
13. Power Cable and Tank Sensor Cable: Feed the power cable from the lower front cover and tank
sensor cable through the heat pump module so they protrude out of the front of the module.
COVER
STRIP
HEAT PUMP
HOUSING
HEAT PUMP
HOUSING
COVER STRIP APPLICATION HEAT PUMP INTEGRATED 410 LITRE
Step 10
apply cover strip to heat pump housing
Steps 11 and 13
31
HEAT PUMP AND TANK ASSEMBLY
ASSEMBLY
DETAIL
COVER
STRIP
SK6570-1 rev BD
1/5/13