Removing And Replacing The Warmer Drawer; To Replace The Warmer Drawer; To Remove The Warmer Drawer; Bearing Glide Placement - Kenmore 970C4256 Use & Care Manual

Removing and Replacing the Warmer Drawer

To remove the warmer drawer:

Electrical shock hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
1. Turn power OFF to the appliance before removing the
warmer drawer.
2. Open the warmer drawer completely.
3. On left warmer drawer rail, locate black release lever and
press up with finger while pulling out slightly on the oven
drawer handle. On right warmer drawer rail, locate black
release lever and press down with finger while pulling out
slightly on the warmer drawer handle (See
Left-hand rail and release
Warmer
drawer
handle
Figure 52: Removing the warmer drawer
4. The warmer drawer should now be released from the rails.
Remove warmer oven drawer (using level and square
motion) completely out and away from the appliance.
Figure 52).
Right-hand rail and release

To replace the warmer drawer:

1. Pull the bearing glides to the front of the outer compart-
ment glide channels until they snap into place (See
Figure 53).
Figure 53: Bearing glide placement
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located inside
the empty warmer drawer compartment (See
Left-hand channel
Figure 54: Channel alignment
3. While holding the warmer drawer level and square using
the warmer drawer handle, push (do not force) the warmer
drawer all the way into the outer compartment glide
channels all the way into the range. Open the warmer
drawer again to verify the glides have seated.
4. If you do not hear the levers "click" or the bearing glides do
not feel seated remove the warmer drawer and repeat
Steps 1 through 3 again. This will minimize possible damage
to the bearing glides.
37
Care and Cleaning
Figure
Right-hand channel
54).