Removing And Replacing The Warmer Drawer - Kenmore 790.7433 Series Use & Care Manual

Oven Controls
Important notes:
• Always start with hot food when using the warmer drawer.
Do not heat cold food in the warmer drawer.
• Self Clean can not be set when the warmer drawer is active.
• The warmer drawer is equipped with a catch that may
require extra force to open and close the drawer.
Removing and Replacing the Warmer Drawer
To remove the warmer drawer:
Electrical shock hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
1. Turn power OFF to the appliance before removing the
warmer drawer.
2.
3.
Open the warmer drawer completely.
On left warmer drawer rail, locate black release lever and
press up with finger while pulling out slightly on the oven
drawer handle. On right warmer drawer rail, locate black
release lever and press down with finger while pulling out
slightly on the warmer drawer handle (See Figure 29).
Left-hand rail and release
\
4. The warmer drawer should now be released from the rails.
Remove warmer oven drawer (using level and square
motion) completely out and away from the appliance.
To replace the warmer drawer:
1. Pull the bearing glides to the front of the outer compart-
ment glide channels until they snap into place (See
Figure 30).
Figure 30: Bearing glide placement
2. Carefully line up both sides of the warmer drawer glide
rails to the outer compartment glide channels located inside
the empty warmer drawer compartment (See Figure 31).
Warmer
drawer'
handle
Figure 29:
\
Right-hand rail and release
Removing the warmer drawer
Figure 31: Channel alignment
3. While holding the warmer drawer level and square using
the warmer drawer handle, push (do not force) the warmer
drawer all the way into the outer compartment glide
channels all the way into the range. Open the warmer
drawer again to verify the glides have seated.
4. If you do not hear the levers "click" or the bearing glides do
not feel seated remove the warmer drawer and repeat
Steps 1 through 3 again. This will minimize possible damage
to the bearing glides.
27