Utax 3005ci User Manual page 468

Troubleshooting > Troubleshooting
Symptom
2 or more sheets are
overlaps when ejected.
(multi feed)
Printouts are wrinkled.
Printouts are curled.
Cannot print.
Cannot print with USB
memory.
USB memory not
recognized.
Printouts have vertical lines.
Dirt on the top edge or back
of the paper.
Checkpoints
―
Are the originals loaded correctly?
―
―
Is the paper damp?
―
Is the paper damp?
Is the paper printed out to the finisher?
Is the machine plugged in?
Is the machine powered on?
Are the printer cable and network cable
connected?
Was the machine powered on before the
printer cable was connected?
Is the print job paused?
Is the USB host blocked?
―
Are the slit glass and the Dual scanning
area dirty?
―
Check the machine interior.
Corrective Actions
Load the paper correctly.
Load the paper correctly.
Clean the paper separator.
Turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned.
Replace the paper with new paper.
Change the [Correct Paper Curl].
Plug the power cord into an AC outlet.
Turn on the main power switch.
Connect the correct printer cable and
network cable securely.
Power on the machine after connecting
the printer cable.
Resume printing.
Select [Unblock] in the USB host
settings.
Check that the USB memory is securely
plugged into the machine.
Clean the slit glass and the Dual
scanning area.
Run [Laser Scanner Cleaning].
Open the right cover. If the machine
interior is dirty with toner, clean it using
soft, dry, lint-free cloth.
10-20
Reference
Page
page 3-18
page 3-26
page 3-18
page 3-26
page 10-4
page xv
page 3-18
page 3-26
page 3-16
page xv
page 3-18
page 3-26
page 3-16
page 8-59
―
page 2-10
page 2-6
―
page 7-4
page 8-50
―
page 10-3
page 10-43
―