Rhfe-1005Ft - Back Panel Installation - Rinnai RHFE-309FT Operation & Installation Manual

HEATER INSTALLATION
3.

RHFE-1005FT - BACK PANEL INSTALLATION

The back panel is NOT an optional component and MUST BE fitted to
ensure the correct and safe operation of the appliance while also
providing concealment and protection of the flue and gas connections.
1. Replace the two short panel brackets (ia) from the back the
appliance with the two long panel brackets (i) supplied with the
back saver kit.
2. Fit left and right cover panels to the rear of the appliance by
fastening into position using the four 6g x 8mm pan head screws
(ii) supplied.
These screws locate into pre-drilled and formed recesses of the
panels, brackets and appliance.
3. Remove the Fan Filter (iii).
4. Carefully fit the top cover panel ensuring the rear fold locates
neatly between the two securing brackets and wall.
5. Secure the top cover panel with three 6g x 8mm pan head
screws supplied (iv).
6. Replace the Fan Filter (iii).
Air hose and heater exhaust connections at the
Energysaver heater MUST be made and checked in
CAUTION
accordance with these instructions.
Improper connections
situations, for example, the dispersion of combustion
products in the space being heated.
NOT INTENDED FOR FIREPLACE INSERT.
NOTE
Rear cover panels MUST BE fitted to ensure correct
and safe operation of the appliance.
WARNING
Failure to fit the rear cover panels will result in
inefficient and dangerous operation of the appliance
and void the warranty.
Rinnai
may result in dangerous
29
Left
Cover
Cover
Panel
Panel
Panel
Brackets
ia
i
iii
ii
iv ii
iv
iv
Top
Right
Cover
Panel
ia
i
ii
iv ii
iv
iii
ES_FT_OIM