Kenwood FGZ80EF2 Instructions For Use Manual page 15

QQ
3 7 63 1515 0
No. Adjustment item
3-K R sub contrast
3-L B sub contrast
3-M VCOM
4 Screen display
starting position
TE
adjustment
L 13942296513
5 Flicker
6 Touch-panel
www
.
ADJUSTMENT
The adjustment method
Carry out the monitor of the waveform of TP528
with an oscilloscope.
Adjst the amplitude value so that the waveform
between the 10 step signal to the negative 10
step signal is 2.2V±0.1V.
Carry out the monitor of the waveform of TP526
with an oscilloscope.
Adjst the amplitude value so that the waveform
between the 10 step signal to the negative 10
step signal is 2.2V±0.1V.
Carry out the monitor of the waveform of TP517
with an oscilloscope.
The amplitude of the adjst the wave of VCOM is
5.8V±0.1V
A menu mode -- returning -- POSI of manufacture Panel top
MODE (NAVI) MENU -- or (AUX) it chooses.
Screen position adjustment of the position
adjustment is carried out by a touch panel.
It adjusts so that the flicker level will be
minimum on screen.
After usually starting a set in the mode and
pressing an information key, a SET icon and a
touch compensation icon are chosen.
The target which appeared in the screen is
pushed in order of the lower left and the upper
right.
x ao
y
i
8
Adjustment
part
CH14
CH15
CH1
It adjusts so that the
icon position of the picture
Q Q
in a screen may
3 6 7 1 3
become in the center.
VR102
Panel top
icon
u163
.
FGZ806EF2/EOP
2 9 9 4 2 8
Adjustment value Conditions
2.2V±0.1V Incoming signal :
10 STEP (NTSC)
/RGB
2.2V±0.1V Incoming signal :
10 STEP (NTSC)
/RGB
5.8V±0.1V Incoming signal :
10 STEP (NTSC)
/RGB
Mono range
1 5 0 5 8 2 9 9 4
Flicker minimum Gray drawing
- -
m
co
9 9
Test point
TP528
TP526
TP517
Screen
2 8 9 9
Screen
Screen
15