ATS83.7=1<enter>
To disable it, type:
ATS83.7=0 <enter>
Dialing out for Analog Adapter Port 1
Using the "A" command following the "ATD" will tell your TA128
to automatically switch call to analog adapter, Phone 1, once dialing
is complete.
Type:
ATDA17146930762<enter>
O
You must have an analog modem connected to your analog
:
NOTE
port before you issue this command.
Dialing out for Analog Adapter Port 2
Using the "B" command following the "ATD" will tell your TA128
to automatically switch calls to analog adapter Phone 2, once dialing
is complete.
Type:
ATDB17146930762<enter>
Manually switching communication modes
The manual switching functions will only be necessary if your
communication software does not allow you to change your dial-up
string.
Conventional dialing commands: ATD, ATDT and ATDP, used by
many existing communication software, can be mapped onto one of
the new dialing commands according to the AT&O setting as
follows:
AT Command Dial string it will map to
AT&O0
AT&O2
AT&O3
20
ATD, ATDT and ATDP are the same as ATDB.
ATD, ATDT and ATDP are the same as ATDI.
ATD, ATDT and ATDP are the same as ATDA.