Controls And Settings; Generator/Welder Controls - Lincoln Electric POWER-ARC SVM103-C Service Manual

B-4

CONTROLS AND SETTINGS

All generator/welder controls are located on the
Output Control Panel. Gasoline engine controls are
mounted on the engine. See Figures B.1 and B.2 and
the explanations that follow.
2
1. CURRENT CONTROL DIAL
2. ELECTRODE SELECTION GUIDE
3. WELD OUTPUT TERMINAL (TO ELECTRODE HOLDER) WITH 1/2 - 13 FLANGE NUT
4. WELD OUTPUT TERMINAL (TO WORK) WITH 1/2 - 13 FLANGE NUT
5. GROUND STUD
6. 20 AMP CIRCUIT BREAKERS (2)
7. 20 AMP, 240 VOLT RECEPTACLE
8. 20 AMP, 120 VOLT DUPLEX RECEPTACLE

GENERATOR/WELDER CONTROLS

See Figure B.1 for the location of the following
features:
1. CURRENT CONTROL DIAL: Adjusts continuous
current output. The amperages on the dial
correspond to the average amperages needed for
specific Lincoln welder rods.
2. ELECTRODE SELECTION GUIDE: Provides
recommended electrode type, size, and welder
output setting based on the thickness of the
work.
OPERATION
FIGURE B.1 – OUTPUT PANEL CONTROLS
POWER ARC 4000
80
70
AMPS
AMPS
125
90
AMPS
AMPS
GENERATOR
100
AMPS
WARNING
ELECTRODE SELECTION GUIDE
4
3
3. WELD OUTPUT TERMINAL (TO ELECTRODE
4. WELD OUTPUT TERMINAL (TO WORK) WITH 1/2
POWER-ARC 4000
1
5
6
HOLDER) WITH 1/2 - 13 FLANGE NUT: Provides
the connection point for either the electrode
holder or the work cable. (Because the POWER-
ARC 4000 is an AC output machine, either output
terminal can be used for either cable.)
- 13 FLANGE NUT: Provides the connection
point for either the electrode holder or the work
cable. (Because the POWER-ARC 4000 is an AC
output machine, either output terminal can be
used for either cable.)
B-4
8
7