Belt Replacement - Land Pride ZT60 Operator's Manual

Section 5: Maintenance & Lubrication

Belt Replacement

Refer to Figure 5-19 and Figure 5-20:
Replace belts which show signs of severe cuts, tears,
excessive weather checking and cracking or burns
caused by slipping. Slight raveling of belt covering does
not indicate belt damage. Trim ravelings with a sharp
knife.
Inspect belt pulley grooves and flanges for wear. A new
belt, or one in good condition, should never run against
the bottom of the groove. Replace pulley when this is the
case, otherwise belt will lose power and slip excessively.
Never pry a belt onto a pulley as this will cut or damage
the fibers of the belt covering.
Keep oil and grease away from belts, and never use belt
dressings. Any of these will destroy the belt composition
in a very short time.
Deck Drive Belt Removal & Installation
Refer to Figure 5-19:
1. Park mower on a flat surface. Stop engine and
remove ignition key. Make sure blade engagement
switch is in the down (OFF) position and spread
both control levers fully apart.
4
5
1
2
1. Ground drive pulley
2. Deck drive pulley
3. Deck drive belt
4. Deck blade spindle pulley (4)
5. Spindle belt tension idler
6. Tension idler spring
9/03/10
Table of Contents
8
7
6
7
3
7. Deck belt idler
8. Idler arm
9. Over-center tensioner
10. Over-center release
(Use 3/4" socket wrench)
11. 1/4" x 1/2" hitch pin
Deck Belt Drive Layout
2. Disconnect negative battery cable.
3. Place deck height in the lowest position.
4. Remove deck belt covers and raise floor panel.
5. Pull hitch pin (#11).
6. Release deck belt tension by putting a 3/4" socket
wrench on the over-center-release bolt (#10) and
turning counterclockwise. This will relieve the
tension on the deck belt idler spring.
7. Pull tension idler (#5) to the left of the machine to
provide maximum belt clearance.
8. Remove existing deck belt (#3).
9. Route new deck belt (#3) as shown in Figure 5-19.
10. Re-tension deck belt idler (#5) by turning the
over-center-release bolt (#10) clockwise. Check belt
tension per the "Deck Drive Belt Adjustment" on
page 28.
11. Re-install hitch pin (#11)
12. Re-install deck belt covers and lower panel.
13. Re-attach the negative battery cable.
4
11
10
Figure 5-19
ZT60 & ZT72 Accu-Z
9
4
®
Zero Turn Mowers 357-103M
23978
45