Land Pride ZT60 Operator's Manual page 42

Section 5: Maintenance & Lubrication
5. Once oil has slowed to a slow drip, reinstall drain
plug (#1) and tighten to correct torque. See "Torque
Values Chart" on page 59.
6. Install new oil filter (#6) as follows:
a. Clean mounting surface that the filter seats against
with a clean rag.
b. Apply a thin coat of oil on the rubber seal surface
of the oil filter.
c. Completely fill oil filter with hydraulic oil.
d. Screw new filter on until it makes contact with the
surface it seats against.
e. Tighten filter an additional 3/4 to 1 full turn more.
7. Add hydraulic oil to the left fill hole (#4) until oil
reaches the top of the fill hole.
8. Reinstall left fill plug (#4) and tighten.
9. Add hydraulic oil to the expansion tank (#5) until it
reaches the full mark on the expansion tank
(approximately 3/4"). Reinstall cap.
10. Wipe off all excess oil. A degreaser may be needed
to remove excess oil.
11. Reinstall reservoir cover (#2).
12. Repeat steps 1 thru 11 for the right side.
1
Right Side
Hydraulic Oil Drain Plugs Location (Bottom View)
Figure 5-9
®
40 ZT60 & ZT72 Accu-Z Zero Turn Mowers 357-103M
Table of Contents
23976
1
Left Side
26693
Hydraulic Oil Filters and Oil Expansion Tank Location
4
3
Left Side Shown
Hydraulic Oil Fill Plugs Location
Figure 5-10
Right Side
5
Left Side
6
Figure 5-11
2
24518
9/03/10