Desa (V)T32N series Owner's Operation And Installation Manual page 29

OPERATION
Continued
MANUAL LIGHTING
PROCEDURE
1. Remove glass door (see Removing/Re-
placing Glass Door, page 24).
2. Follow steps 1 through 7 under Lighting
Instructions, page 28.
3. Press gas control knob and light pilot with
match.
4. Keep gas control knob pressed in for
30 seconds after lighting pilot. After 30
seconds, release gas control knob. Fol-
low steps 9 through 12 under Lighting
Instructions, page 28.
5. Replace glass door (see Removing/Re-
placing Glass Door, page 24).
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be pur-
chased separately (see Accessories, page 37). Fol-
low instructions included with the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 28.
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON position.
Adjust flame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 53).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
Blower Control Knob
(Optional Accessory)
OFF
Selector Switch in
Remote Position
Figure 53 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
111986-01F
Variable
Control Knob
ON
Gas Control Knob in
ON Position
www.desatech.com
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
ON/OFF SERIES
(MODELS HRC100 AND HRC101)
Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 54).
TO LOCK press both buttons on hand-held
remote control until light stops flashing. Hand-
held remote control is now locked. If the fire
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 54 - On/Off Hand-Held Remote
Control Unit HRC100
THERMOSTAT SERIES
(MODEL HRC200 AND HRC201)
The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure 55,
page 30). To select Fahrenheit/Centigrade
mode display, carefully press the ˚C/˚F mode
button with the end of a paper clip or similar
blunt object.
Manual Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press the MANU button to turn on fire-
place.
3. Press POWER and LOCK buttons to-
gether to turn off fireplace.
Auto (Thermostatic) Mode
1. Press POWER and LOCK buttons togeth-
er to turn on hand-held remote control.
2. Press AUTO button to select this mode.
3. Set desired room temperature by pressing
the TEMP + or - buttons.
4. Press POWER and LOCK buttons to-
gether to turn off fireplace
Control
Button
29