Desa (V)T32N series Owner's Operation And Installation Manual page 26

FIREPLACE
INSTALLATION
Continued
6. Place log #6 (left log) onto two pins on left
side of back and front log. See Figure 48.
7. Place lava rock along sides and front of firebox
bottom in areas that are visible only. It is not
necessary to use all of lava rock provided.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner will cause
performance problems.
8. Pull ember material apart into pieces no
larger than a dime. Place these pieces
loosely and sparingly directly onto exposed
section of front burner and along space be-
tween burner and grate prongs (see Figure
49). This will create glowing ember appear-
ance as flame touches ember material. Do
not block air slots by using too much ember
material in one area. It is not necessary to
use all of ember material provided.
Figure 44 - Installing Log No. 1
Figure 45 - Installing Log No. 2
26
9. Close glass door, lock door latches, replace
screen and close louvers (see Removing/
Replacing Glass Door, steps 5 through 7,
page 24).
be securely in place before running
this fireplace. Do not run this fireplace
if glass is missing or broken.
Figure 46 - Installing Log No. 3
Figure 47 - Installing Log No. 4
Figure 48 - Installing Logs No. 5 and No. 6
Ember Material
Figure 49 - Placing Ember Material on
www.desatech.com
WARNING: The glass door must
Burner
111986-01F