Table of Contents
Advertisement
220
WFS
AMPS
Less
More
Shorter
Deposition
Deposition
Arc
WELD MODE
ELECTRODE AND GAS
Steel
CO
2
Steel
Ar(Mix)
Stainless
Ar(Mix)
Stainless
Ar/He/CO
2
Aluminum 4043
Ar
Ar
Aluminum 5356
WAVEFORM CONTROL TECHNOLOGY
10
IR PORT
CV CO2
WELD MODE
ARC CONTROL
ARC CONTROL
EFFECT / RANGE
Pinch controls the arc characte-
PINCH EFFECT
-ristics when short-arc welding.
(-10.0 to +10.0)
26.4
VOLTS
TRIM
Longer
Arc
WIRE SIZE
0.030 0.035 0.045 0.052
---
10
20
24
94
11
21
25
61
31
41
---
63
33
43
---
---
148
71
---
---
151
75
---
STEEL
.035"
SETUP
START OPTIONS
END OPTIONS
SET
DESCRIPTION
-
START OPTIONS
EFFECT / RANGE
Preflow Time
Adjusts the time that shielding
0 - 10 seconds
gas flows after the trigger is
pulled and prior to feeding.
Run-in WFS:
Run-In sets the wire feed
Off, 50 to150 in/min.
speed from the time the trigger
is pulled until an arc is estab-
lished.
Start Procedure
The Start Procedure controls
the WFS, Volts at a specified
time at the beginning of the
weld. During the start time, the
machine will ramp up or down
from the Start Procedure to the
preset Welding Procedure.
END OPTIONS
EFFECT / RANGE
DESCRIPTION
Postflow Time
Adjusts the time that shielding
0 to 10 seconds
gas flows after the welding out-
put turns off.
Burnback:
The burnback time is the
0 to .25 Seconds
amount of time that the weld
output continues after the wire
stops feeding. It prevents the
wire from sticking in the puddle
and prepares the end of the
wire for the next arc start.
Crater Procedure
Crater Procedure controls the
WFS and volts for a specified
time at the end of the weld
after the trigger is released.
During the Crater time, the
machine will ramp up or down
from the Weld Procedure to
the Crater Procedure.
DESCRIPTION
Advertisement
Table of Contents
