Table of Contents
Advertisement
7. Color Reproduction Adjustment
Adjust the color Separation matrix coefficient so that proper color
reproduction is produced.
Subject
Color bar chart
(Color reproduction adjustment frame)
Measurement Point
Video output terminal
Measuring Instrument
Vectorscope
Adjustment Page
F
Adjustment Address
4E, 50, FB, FC
Specified Value
All color luminance points should
settle within each color reproduction
frame.
Note: NTSC 720H model:DCR-TRV410/TRV510
PAL 960H model: DCR-TRV410E/TRV510E
Switch setting:
1)
NIGHT SHOT .................................................................. OFF
2)
DIGITAL ZOOM (Menu display) ................................... OFF
3)
STEADY SHOT (Menu display) ..................................... OFF
Adjusting method:
1)
Select page: 0, address: 01, and set data: 01.
2)
Select page: F, address: E1, set data: 1B, and press the PAUSE
button of the adjustment remote commander.
3)
Select page: F, address: 27, set data: 3F, and press the PAUSE
button.
4)
Select page: 6, address: 01, set data: 3D, and press the PAUSE
button.
5)
Adjust the GAIN and PHASE of the vectorscope, and adjust
the burst luminance point to the burst position of the color
reproduction frame.
6)
Change the data of page: F, address: 4E, 50, FB and FC, and
settle each color luminance point in each color reproduction
frame.
Note: Be sure to press the PAUSE button of the adjustment remote
commander before changing the addresses. If not, the new data
will not be written to the memory.
Processing after Completing Adjustments
1)
Select page: 6, address: 01, set data: 00, and press the PAUSE
button of the adjustment remote commander.
2)
Select page: F, address: E1, set data: 20, and press the PAUSE
button.
3)
Select page: 0, address: 01, and set data: 00.
NTSC 720H model
Burst position
PAL 960H model
Burst position
5-25
Fig. 5-1-10.
Hide quick links:
Advertisement
Table of Contents
