Sony Digital8 DCR-TRV410 Service Manual page 10

Self-diagnosis Code
Block Detailed
Function Code
Difficult to adjust focus
E 6 1 0 0
(Cannot initialize focus.)
Zoom operations fault
E 6 1 1 0
(Cannot initialize zoom lens.)
Handshake correction function does not
E 6 2 0 0 work well. (With pitch angular velocity
sensor output stopped.)
Handshake correction function does not
E 6 2 0 1 work well. (With yaw angular velocity
sensor output stopped.)
Symptom/State
— 10 —
Correction
Inspect the lens block focus reset sensor (Pin !™ of CN551 of VC-
213 board) when focusing is performed when the control dial is
rotated in the focus manual mode and the focus motor drive circuit
(IC551 of VC-213 board) when the focusing is not performed.
Inspect the lens block zoom reset sensor (Pin !¢ of CN551 of VC-
213 board) when zooming is performed when the zoom lens is
operated and the zoom motor drive circuit (IC551 of VC-213 board)
when zooming is not performed.
Inspect pitch angular velocity sensor (SE651 of SE-88 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE652 of SE-88 board)
peripheral circuits.