Table of Contents
Advertisement
All brakes are easy to access thanks to the
design of the frame.
1.
1. Height adjustment
Lift the armrest slightly upwards in order to
pull the pin out. Adjust the support platform
to the required height. Check that the pin is pressed
in correctly in order to lock the height adjustment.
Do not pull out the pin if the user is putting
weight on the support platform
Lift the lever and adjust the support platform
to the required height by pulling upwards or
pushing gently on the armrests.
3.
3. Adjustment of width between armrests
Loosen the knob that is located between the arm-
rests and adjust sideways to the required width.
Lock them again by tightening the knob.
The height of the back part of the frame is low
to allow the platform to roll under furniture
which facilitates movement to and from a
seated position.
The height of the back part is 215 mm with
standard wheels and 190 mm with 100 mm
wheels (option).
Adjustment
Use the hand control to adjust the support
platform upwards or downwards. A green
light on the control unit indicates that the
electrical motor is in use.
2. Emergency stop and emergency lowering
If it is necessary to make an emergency stop press
the red button (A) on the right of the
control unit. Turn the same button clockwise to
reset.
If emergency lowering is necessary, press the button
on the front of the control unit (B).
4.
4. Handle adjustment
Undo the knob that is located under the armrests
and adjust the handles to the required depth and
angle. Lock the handles by retightening the knob.
DOLOMITE STEP UP
125 mm
A
B
2.
5
Advertisement
Table of Contents
